Magma UPGTB2 Instalační příručka stáhnout pdf (Strana 11)

Magma

Thunderbolt™ 2 Interface Card | Thunderbolt™ 2 for EB1T

Thunderbolt™ 2 for EB1T

Interface Card Installation

Remove Thunderbolt™ 1 Interface card in the chassis prior to installing the new Thunderbolt™ 2 Interface card.

WARNING

High voltages are present inside the expansion chassis when the unit’s power cord is plugged into

an electrical outlet. Disconnect the power cord from the AC outlet before removing the enclosure

cover. Turning the system power off at the power on/off switch does not remove power to

components. High voltage is still present.

1. Remove the screw on top of the mounting bracket.

2. Disconnect the 3-pin wire / power cable from the Interface card, as shown from pictures below.

1. Gently pull the Thunderbolt™ 1 Interface card out in the PCIe slot.

2. Prepare the new Thunderbolt™ 2 Interface card.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18 19

Žádné komentáře

Magma UPGTB2 Instalační příručka Strana 11